Connecting the Control Unit Without On-Site Internet

Components Required for Initial Setup

• EH-01 control unit with power supply (both included in the package).
• A mobile device with the Sinum app or another device that supports the Sinum application.

Downloading the Sinum App

1. Open the App Store (for iOS) or Google Play Store (for Android).
2. Search for and download the Sinum app.
3. The app enables full control and management of the control unit.

App Store:

https://apps.apple.com/pl/app/sinum/id1598099137?l=pl

Google Play Store:

https://play.google.com/store/apps/details?id=tech.sinum

List of All LEDs

Connecting the Control Unit to Power

1. Remove the control unit and the power supply from the package.
2. Connect the power supply to the control unit.
3. Wait approximately 2 minutes until the sixth LED from the left lights up – this indicates that the control unit is operating correctly.

Activating Access Point Mode

1. Activate Access Point mode on the control unit by holding down the MODE button located on the back of the device until the eighth LED blinks three times.
2. About 5 seconds after pressing the button, the LED indicating Wi-Fi connection will start blinking.

• • If the mode does not start, press and hold the button again.
  • If several attempts fail, restart the device.

1. In Access Point mode, the control unit broadcasts its own Wi-Fi network.

• • Enable Wi-Fi on your mobile device.
  • Connect to the network named “ap_sinum”.

1. After connecting to the network, the configuration portal will appear.

• • If the portal does not open automatically, enter the following address in your browser: 4.3.2.1

Tworzenie konta w centrali Sinum

1. Aby rozpocząć konfigurację, musisz założyć konto globalne.

   • Konto to będzie posiadało uprawnienia do edycji wszystkich funkcji systemu.

2. Kliknij Dalej.
   
   

3. Wpisz nazwę użytkownika oraz hasło, a następnie kliknij Dalej.
   
   

4. Zaakceptuj politykę prywatności oraz regulamin.

5. Kliknij Zakończ, aby zakończyć proces rejestracji.

Aby przejść do dalszych kroków konfiguracji, otwórz zakładkę „Konfiguracja systemu”.